6L/9L Two Way Air/Pneumatic Oil and Liquid Extractor Automatic Transmission Fluid Pump Set

$60.00

SKU: Model: MG-082647 Category:




Including 4 tubes
4mm×39 inches
6mm×39 inches
8mm×37.7 inches
10mm×39.4 inches

 

How To Use bacoeng 7L Oil Extractor?
1) Warm up the oil by running the engine. This will allow the contaminates to mix and to suspend in the oil. Remove the dipstick. Note: If you can’t hold the dipstick comfortably in your hands, then the oil is too hot! Wait for the oil to cool off a bit. 
2) Select and insert the appropriate diameter extraction tube into the dipstick pipe until it touches the bottom of the oil pan. Connect the main tube to the top of the unit and to the extraction tube. 
3) Pump the handle 4 to 10 times in a row to start the vacuum. The unit will extract the oil automatically. Continuous pumping is not required.
4) After all the oil has been extracted, press the release valve located at the top of the unit for 5 seconds. Remove the main tube. When pouring the oil into a container, hold the pump as in the photo and pour gently. Do not hold it upside down ! Bring the used oil to a recycling depot.

Reviews

There are no reviews yet.

Be the first to review “6L/9L Two Way Air/Pneumatic Oil and Liquid Extractor Automatic Transmission Fluid Pump Set”

Your email address will not be published.

Shopping Cart