Be1 Bernini Controller
Auto Start Front Panel
The Be1 Bernini Controller is a user-friendly generator AUTO START MODULE. By adding only a few automotive relays you can make an auto-start panel in a little time. Be1 interfaces with any kind of sensor: analog or digital.
You can use Be1 Bernini Controller to refurbish the control panel of any style of engine: gas, gasoline, or diesel. In case you need to control the engine by remote, Be1 features a powerful serial interface that supports the MODBUS protocol. Software is provided free of charge. Thanks to the high-quality silicone gasket the Be1 features IP65 ingress protection.
The START/STOP push buttons are redundant, in this way you can expect a long life even in harsh environments. Be1 features an’ avionics grade’ display that will allow you full visibility of the instruments between -30 up to 70-degree Celsius. In case of shuts down the Be1, in addition to alarm messages on the display turns on a red light in case of Engine Failure (Oil, Temperature…), Over Speed and Fail to start
Generator Auto Start Kit Specifications
Battery supply voltage: 5.5Vdc to 36Vdc. Supply current: 10 mA to 80mA. Inputs: digital (switch) or analog (0-1000 OHM).
Dimensions: 96X96X 47(mm). Panel Cut-out: 91mm X 91mm. Ingress protection: IP65. Outputs: 300mA, NPN short circuit proof.
Operating temperature range: -30 deg C up to +70 deg C. Humidity range: 5% up to 95% non-condensing.
Weight: 350 gr., Vibration: 40mm/sec. Pick-up Input: Voltage input: 2 – 60Vac; 0-10KHz
Generator Monitoring: Operating up to 600Vac. Accuracy: +/- 1,5%. Frequency: 20-70Hz
For more products, check this: B124 Bernini Controller
For more related products, click here.
Reviews
There are no reviews yet.