AOSIF 100KW 125KVA Cummins Diesel Generators Exported Detroit Cummins Power Generation
- Brand:
AOSIF
- Item No.:
AC138
- Prime Power:
100KW/125KVA
- Engine:
Cummins
- Alternator:
Leroy somer /Stamford/Marathon/ AOSIF
- Frequency:
50HZ
- Controller:
Deepsea 6120
Related Presentations
General feature:
♦ Assembled by Cummins diesel engine and Leroy Somer alternator.
♦ Three filters as standard, fuel and water separator as optional.
♦ Radiator and fan with safety guard.
♦ Single bearing alternator IP 23, Insulation Class H.
♦ 12V battery, battery wires.
♦ Battery charger and float battery charger as standard supply scope.
♦ Optional soundproof canopy, ATS, synchronization panel, movable trailers.
Genset Open Version Genset Soundproof Version
Open Type (Standard Configuration) | Soundproof Type |
Overall Size:2144×785 ×1365mm(L*W*H) | Overall size: 3100× 1050×1830mm(L*W*H) |
Weight: 1243kg | Weight: 1723kg |
Genset Main Technical Data:
Genset Model | AC138 |
Prime Power | 100KW / 125KVA |
Standby Power | 110KW / 138KVA |
Frequency/Speed | 50Hz/1500rpm |
Standard Voltage | 240V/415V |
Phases | Three phases, four wires |
Manufacturer | Xiamen AOSIF Engineering LTD. |
Cummins Engine Data:
Manufacturer | Dongfeng Cummins Engine Co., Ltd. |
Model | 6BTA5.9-G2 |
Engine speed | 1500rpm |
Engine power | |
—————————-Standby power | 116kw / 155HP |
—————————-prime power | 106kw / 142HP |
Aspiration | Turbocharged & Aftercooled |
Cylinder quantity | 6 line |
Bore * Stroke | 102*120mm |
Displacement | 5.9L |
Fuel system | BYC PB/ Electronic Governor |
Speed-droop | ≤5% |
Low idle | 750-850 rpm |
Piston speed | 6.0 m/s |
Friction energy output | 12.7 kw |
Max. exhaust back pressure | 10kPa |
Exhaust Pipe Size Normally Acceptable | 75mm |
Maximum Static Supported Weight at the Turbocharger Outlet Flange | 13.5 N.m |
Exhaust gas flow (prime power – standby power) | 305-334 L/sec |
Exhaust temperature (prime power – standby power) | 540-570 ℃ |
Max. air intake resistance | |
Dirty Element | 6kPa |
Clean Element | 3.7kPa |
Minimum Dirt Holding Capacity with Heavy Duty Air Cleaner | 53g/cfm |
Maximum Temperature Rise from Ambient to the Inlet of the Turbocharger | 17 ℃ |
Recommended intake piping size (inner diameter) | 76mm |
Air intake flow (prime power – standby power) | 112-118 L/sec |
Normal oil pressure range | |
————idle speed | 207 kPa |
———–governor speed | 345 kpa |
Max. oil temperature permitted in oil pan | 121 ℃ |
Oil Capacity with OP 9006 Oil Pan : High – Low | 14.2-12.3L |
Minimum required lube system capacity-sump plus filters | 16.4L |
Angularity of Standard Oil Pan: (Values stated are for intermittent operation only): (any direction) | 40 ° |
Type Injection System | BYC PB direct injection |
Maximum Restriction at Lift Pump | 13.6 kPa |
Maximum Allowable Head on Injector Return Line (Consisting of Friction Head and Static Head) | 67.7 kPa |
Total Drain Flow | 30 L/h |
Coolant capacity – engine only | 10L |
Max. coolant cycling resistance exterior engine | 28 kPa |
Maximum Static Head of Coolant Above Engine Crank Centerline | 14m |
Thermostat adjusting temperature (range) | 82-95 ℃ |
Min. opening pressure of radiator cap | 69 kPa |
Maximum Top Tank Temperature for Standby/Prime Power | 104 / 100 ℃ |
Engine coolant flow (prime power – standby power) | 2.0 L/s |
Cranking Motor (Heavy Duty, Positive Engagement) | 12V |
Battery Charging System, Negative Ground | 63A |
Maximum Allowable Resistance of Cranking Circuit | 0.00075 Ω |
Minimum Recommended Battery Capacity • Cold Soak @ 10 °F (-12 °C) and Above | 800 0°F CCA |
Alternator Data:
Manufacturer | Leroy-somer Electro-technique (Fuzhou) Company Ltd. |
Model | LSA44.3M6 |
Output power | 100KW |
AVR model | R250 |
Number of phase | 3 |
Power factor (Cos Phi) | 0.8 |
Altitude | ≤ 1000 m |
Overspeed | 2250RPM |
Number of Pole | 4 |
Exciter type | Shunt |
Insulation class | H |
Voltage regulation | ±0.5% |
protection | IP23 |
Totale Harmonic distortion THD (**) on linear load | < 5 % |
Wave form : NEMA = TIF | < 50 |
Totale Harmonic distortion THD (**) in no-load | < 2% |
Bearing | single |
Coupling | Direct |
Generator Detail
Our Sales Promises★ AOSIF Engineering provides a full line of brand new and high quality products. Each and every unit is strictly factory tested before shipment.
★ Quality Warranty is according to our standard conditions: 12 months from BL date or 1,000 running hours, whichever comes first.
★ Service and parts are available from XIAMEN AOSIF Engineering Ltd. or distributors in your location.
★ All the products from Xiamen AOSIF Engineering Ltd. is CE marked.
Technical Parameters
Reviews
There are no reviews yet.