Trans-Syncro. Synchronising & Load Sharing Controller

Trans-Syncro. Synchronising & Load Sharing Controller
Auto start load share unit, Automatic and manual start, Multi genset load sharing, Busbar voltages and frequency measurements, Dead bus sensing, Bus failure detection, Sequential set start, Manual voltage/frequeny adjustment, Equal aging of gensets, Direct/reverse governor and AVR control, Synchroscope, Programmable PLC functions
Specifications
Communication interface        USB programming and communication port, CanBus communication with 1939 ECU, CanOpen, Ethernet, RS485
Inputs 13x Configurable digital, 4x Analogue senders, Magnetic Pickup,
Charge Alternator D+(WL) inputs
Outputs            Configurable 2x Relays, 7x Transistors, GBR outputs
Current Measurement 3 phases CT inputs for Load Current, 1x CT input for Earth Current
Voltage Measurement 3 phases for Alternator
Power Factor Measurement      For 3 phases
Case
Dimensions      276mm x 189mm x 45mm
Panel Cut-Out 223mm x 162mm
Protection        NEMA 4X IP65 at front side
Weight             Approximately 0,53Kg
Ratings
DC Battery Supply range         8 to 32Vdc, max. operating current is 360mA
CT Secondary 5A
Sender Measurement
0 to 1300 ohm, accuracy: 1%FS, resolution: 1 ohm
Cabin. Temp. Measuremet         -50 to +100 ºC, accuracy: 1 % FS, resolution: 1 ºC.
Operating / Storage Temp.       -20°C to +70°C / -30°C to +80°C