Generator Speed Control Unit ESD5220 is rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment. If water, mist or condensation may come in contact with controller, it should be mounted certically. This will allow the fluid to drain away from the speed control unit.
| Generator speed control engine governor module ESD5220 | |
| Isochronous Operation/Steady State Stability | ± 0.25% or better |
| Speed Range/Governor | 1K-7.5K Hz continuous |
| Speed Drift with Temperature | ± 1% Maximum |
| Idle Adjust CW | Min. 1200Hz. below set speed |
| Idle Adjust CCW | Min. 4100Hz. below set speed |
| Droop Range | 1-5% regulation |
| Droop Adj. Max. (K-L connected) | 875Hz., ± 75Hz. per 1.0 A change |
| Droop Adj. Min. (K-L connected) | 15Hz., ± 6Hz. per 1.0 A change |
| Speed Trim Range | ± 200Hz |
| Remote Variable Speed Range | 500 -7.5Hz. or any part thereof |
| Terminal Sensitivity | J: 100Hz., ± 15Hz/Volt @ 5.0 K Impedance |
| L: 735Hz., ± 60Hz/Volt @ 65 K Impedance | |
| N: 148Hz., ± 10Hz/Volt @ 1Meg. Impedance | |
| P: 10V DC Supply @ 20ma Max | |
| Speed Switch Adjustment Range | 1000-10000Hz. |
| ENVIRONMENTAL | |
| Ambient Operating Temperature Range | -40°c to +85°c |
| Relative Humidity | up to 95% |
| Storage Temperature | -55°c ~ 90°c |
| Shock | 20-100HZ 500mm/Sec. |
| INPUT POWER | |
| Supply | 12 or 24V DC Battery Systems(Transient and Reverse Voltage Protected) |
| Polarity | Negative Ground(Case Isolated) |
| Power Consumption | 50mA continuous plus Actuator current |
| Maximum Actuator Current at 25 | 10Amps continuous |
| Speed Sensor Signal | 0.5-120 Volts RMS
|
Reviews
There are no reviews yet.